INTRODUCTION
This version can be plugged directly into the OBD2 port so no additional wiring is necessary.
FEATURES
Configure the lower and upper RPM settings with or without the engine running. Engine only needs to be revved to 50% of max RPM if setting up with engine running, or manually input RPM values using Push Button at rear of Shift Light.
Configure day and night brightness of the LED’s
Choose from 6 Shift Light Patterns - either linear or converging.
Comes with a dedicated 1.5 meter OBD2 Cable.
SHIFT LIGHT PATTERNS
OBD PROTOCOLS
The Gear Indicator (OBD2) will work on a wide range of cars equipped with an OBD2 Port. To check your car is compatible make sure your OBD port works of one of these OBD2 Protocols:
- SAE J1850-PWM
- SAE J1939
- ISO 9141
- ISO 14230
- ISO 15765-4
Please note the Shift Light OBD2 is not compatible with OBD splitters and should be the only device plugged into the OBD port. It cannot be hardwired to the vehicle network.
Specification
| Size: |
W = 75mm H =18mm D = 29mm |
| Weight: |
55g |
| Operational Voltage: |
7v - 18v |
| Operating Temperature: |
-10 -+85 degrees C |
| Storage temperature: |
-40°C - +125°C |
| Enclosure: |
PA 2200 Nylon fully potted. IP64 rated |
| Mounting: |
2 x M3 screws under Shift Light or 2 x M3 screws on rear of Shift Light |